What Everybody Ought To Know About How To Build A Sten Gun

Material in front of this point is removed using a 2mm or 3mm grinding disc aimed at a 45.

How to build a sten gun. Run the entire length.010 deep on one spot and repeat until the whole slot is cut. The sten (or sten gun) is a family of british submachine guns chambered in 9×19mm which were used extensively by british and commonwealth forces throughout world war ii and the. Here’s another design sent in, this time for a simplified copy of the classic sten gun.

Start with the long charging handle slot. Make sure to check out the full review on gunsamerica: The goal is to connect the ⅜”diameter drilled hole at.

Once complete, the ejector channel is cut into. The sten or sometimes known as the beer can smg, cost roughly $6.00 us to make in '42 compared to the $11.00 us. The sten gun remained in service until the late 1950s.

As pictured, it’s possible to construct a clone of the original bolt using only a. The mark 2 barrel collar you could probably get away with screws, mark 3 screws/rivets for the barrel not a big deal. Sten mk2 build from parts kit with master gunsmith phil oxley at interfor usa group

Sten mkii machine plans created date: The sear contact point is cut into the bolt by using a hacksaw to mark a line, after which. Sten mk.ii gun that shoot|how to make sten mk.ii gunhi i am samiulkise ho ap sab dosto???

Grinding until around 8mm in width. I doubt you can build a sten without some welding. Make sure the magazine housing is square to the lower receiver.